Installation Instructions B246
Extended Bars Sconce 20-5910 Page 1 of 1
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
26952
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all applications. If
installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall and Install Glass (Figure 1)
Component Parts
A Thumb Screw F Ground Screw
B Forged Bars G Crossbar
C Fixture Bracket (2) H Threaded Stud (2)
D Support Rod (2) I Knurled Ball (2)
E Glass J Thumb Screw
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar (G) to the
electric box making sure that fixture mounting holes are level.
Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.
3. Thread studs (H) into the appropriate holes in the crossbar (G). Adjust
the studs to proper length to ensure the fixture will fit snugly to the wall.
4. Hold the fixture assembly close to the wall and using suitable wire
connectors, not provided, connect fixture wires to supply (white to white
or ribbed and black to black or smooth). Run a pigtail lead from crossbar
ground screw (F) to the junction box and connect all ground wires (bare
copper or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and no
bare wire is exposed.
5. Slide fixture assembly over threaded studs (H) and push firmly to wall,
making sure that no wires are pinched between fixture back and wall.
Fasten with knurled balls (I). Be sure threaded studs (H) are fully seated
in the knurled balls (I).
6. Install light bulbs (not included)
7. Slide support rods (D) into holes in glass (E) threading the binding screw to the rod.
8. Lower glass (E) into fixture and engage support rods (D) with notches in fixture bracket (C).
9. Secure glass by inserting thumb screw (J) into threaded hole in bottom bracket of fixture.
10. Install decorative cage (B) over glass (E) and secure by inserting thumb screw (A) through hole in top of
decorative cage and into threaded hole in top bracket of fixture (C).
11. Restore electricity at main breaker
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR
DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the construction
and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(1 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce