Installation Instructions B258
Extended Bars Sconce 20-5910F Page 1 of 1
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735
27004
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all applications. If
installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
To Mount Fixture to Wall and Install Glass (Figure 1)
Component Parts
A Thumb Screw F Crossbar
B Forged Bars G Threaded Stud (2)
C Fixture Bracket (2) H Knurled Ball (2)
D Support Rod (2) I Glass
E Ground Screw J Thumb Screw
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Carefully unpack the fixture from the carton.
2. Using two machine screws (not provided), fasten the crossbar (F) to the
electric box making sure that fixture mounting holes are level.
Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.
3. Thread studs (G) into the appropriate holes in the crossbar (F). Adjust the
studs to proper length to ensure the fixture will fit snugly to the wall.
4. Hold the fixture assembly close to the wall and using suitable wire
connectors, not provided, connect fixture wires to supply (white to white
or ribbed and black to black or smooth). Run a pigtail lead from crossbar
ground screw (E) to the junction box and connect all ground wires (bare
copper or green to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and no
bare wire is exposed.
5. Slide fixture assembly over threaded studs (G) and push firmly to wall,
making sure that no wires are pinched between fixture back and wall.
Fasten with knurled balls (H). Be sure threaded studs (G) are fully
seated in the knurled balls (H).
6. Install light bulb. (included)
7. Slide support rods (D) into holes in glass (I) threading the binding screw to the rod.
8. Lower glass (I) into fixture and engage support rods (D) with notches in fixture bracket (C).
9. Secure glass by inserting thumb screw (J) into threaded hole in bottom bracket of fixture.
10. Install decorative cage (B) over glass (I) and secure by inserting thumb screw (A) through hole in top of
decorative cage and into threaded hole in top bracket of fixture (C).
11. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR
DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the construction
and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(1 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce