Hubbardton-forge 205105 Uživatelský manuál stáhnout pdf

Glass Installation Instructions B22

Page 1 of 2

Your new lighting fixture has been shipped with the glass installed. It may be necessary to remove the glass when

installing the fixture.

To Remove Glass

1. Remove the knurled balls at the sides of the glass.

2. Remove the leaf assembly and glass from the screws. Remove one side at a time.

To Install Glass

Note: The bracket is slightly bent toward the wall. This provides tension in the bracket, which holds the glass securely to

the wall. The amount of tension may be adjusted by bending the bracket slightly as needed.

1. Place the hooked portion of the leaf

assembly over the front edge of the glass so

the curled ends of the leaf assembly line up

with the holes in the side of the glass.

2. Gently pull one side of the bracket away

from the wall and slide one side of the glass

and leaf assembly over the screw.

3. Attach the other side in the same manner

using a rocking motion. It is not possible to

attach both sides simultaneously.

4. Secure the glass and leaf assembly using the

knurled balls.

5. Adjust the glass to level by turning the two

adjusting screws as needed.

(continued)

Hand-Forged, Vermont-Made Lighting and Accessories

P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

14045

1 2

Glass Installation Instructions B22 Page 1 of 2 Your new lighting fixture has been shipped with the glass installed. It may be necessary to remov

Installation Instructions B11 For Direct Wire Wall Mounted Fixtures – B Page 2 of 2 CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN

Žádné komentáře

Hubbardton-forge 205105 Uživatelský manuál