Hubbardton-forge 18755 Uživatelský manuál stáhnout pdf

Assembly Instructions A8

Hand-Forged, Vermont-Made Lighting and Accessories

P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 14012 Rev C

For Adjustable Fixtures Page 1 of 2

Components

A Canopy

B Clutch

C Clutch sleeve

D Set screw

E Canopy pipe

F Fixture pipe

G Fixture wires

To Assemble

1. Carefully unpack the fixture from the carton.

2. Thread the wires from the fixture pipe (F) into and through the canopy

pipe (E) up through the canopy (A). Depending on the fixture, the

canopy pipe may be the larger or the smaller diameter of the two.

3. Unscrew the clutch (B) from the larger diameter pipe (either E or F);

slide it across the wires and onto the smaller diameter pipe (either E or

F). Follow this with the clutch sleeve (C), so it nests in the clutch (B).

4. Slide the smaller pipe (E or F) as far as necessary to give you the total

length of the fixture which you desire. Be careful not to scratch the pipe

surfaces and to pull excess wire up through the canopy (A). There must

be a minimum 1-1/2" of inner pipe inside the outer pipe. Hand-

tighten the clutch to temporarily hold this adjustment. At this point the

adjustment is not securely fastened; do not depend on it to hold the

fixture.

Important: To ensure full connection strength, be sure the tapered end

of the plastic clutch sleeve is oriented toward the clutch when assembled

and securely tighten set screw (Figure 2).

5. Stop. Please see installation instructions on other side.

6. Once the fixture is fastened to the ceiling, tighten the set screw (D)

firmly with hex wrench provided. Only after the set screw (D) is tight

should you install the glass.

Note: If your fixture has more than one set of pipes or stems in the

canopy you will need to level the fixture. While always leaving one clutch

firmly locked with the set screw, loosen the other(s). Raise or lower the

pipe(s) in the other clutch to obtain plum and level and then tighten the

set screw(s).

(continued)

This illustration represents a typical

two-stem fixture. Single- and four-stem

fixtures follow the same procedure.

(Figure 1)

(Figure 2)

1 2

Assembly Instructions A8 1

Shrnutí obsahu

Strany 1 - Assembly Instructions A8

Assembly Instructions A8 Hand-Forged, Vermont-Made Lighting and Accessories P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 14012

Strany 2

Assembly Instructions A8 Hand-Forged, Vermont-Made Lighting and Accessories P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 14012

Komentáře k této Příručce

Žádné komentáře

Hubbardton-forge 18755 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Osvětlení Hubbardton-forge 18755. Hubbardton Forge 18755 User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Osvětlení Hubbardton-forge 18755