Hubbardton-forge 126703 Uživatelský manuál stáhnout pdf

Assembly & Installation Instructions A185

For Semi-Flush Fixtures 12-6703 & 12-6703F Page 1 of 2

Hand-Forged, Vermont-Made Lighting and Accessories

P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

22125

To Install Fixture (Figure 1)

Component Parts

A Ground Screw

B Cross Bar

C Threaded Stud (2)

D Canopy

E Knurled Ball (2)

Caution: Be sure power is off at the main breaker box prior to installation.

1. Carefully unpack the fixture from the carton.

2. Thread studs (C) through appropriate holes in cross bar (B) to match hole

centers in canopy (D). Move ground screw (A) to another available threaded

hole if necessary.

3. Using two machine screws (not provided) fasten cross bar (B) to the electric

box using outer oval holes to orient fixture to desired hanging position.

Note: A new electric box comes with screws. When replacing an existing

fixture, retain the screws for use with the new fixture.

5. Using suitable wire connectors (not provided); connect fixture wires to supply

wires (white to white and black to black). Connect all ground wires to green ground

screw (A).

Caution: Make sure wire connectors are twisted on securely, and no bare wire is

exposed.

6. Slide fixture canopy (D) over threaded studs and push firmly to ceiling, making

sure that no wires are pinched between fixture canopy and ceiling. Fasten with

knurled balls (E). Be sure studs (C) are fully seated in knurled balls (E).

To Install Glass

(Figure 2)

Component Parts

F Retaining Ring

G Glass

H Socket

1. If the water glass option was purchased proceed to section below.

2. Remove retaining ring (F) from socket (H). Retaining Rings are shipped installed.

3. Place glass (G) over socket (H).

4. Replace retaining ring (F) and tighten to secure glass. Do not over-tighten.

5. Install light bulb. (Fluorescent bulbs included with fixture)

6. Restore electricity at the main breaker.

(continued)

(Figure 1)

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL

INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the

construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

(Figure 2)

1 2

A185 1
22125 1

Shrnutí obsahu

Strany 1 - 22125

Assembly & Installation Instructions A185 For Semi-Flush Fixtures 12-6703 & 12-6703F Page 1 of 2 Hand-Forged, Vermont-Made Lighting and A

Strany 2

Assembly & Installation Instructions A185 For Semi-Flush Fixtures 12-6703 & 12-6703F Page 2 of 2 Hand-Forged, Vermont-Made Lighting and A

Komentáře k této Příručce

Žádné komentáře

Hubbardton-forge 126703 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Osvětlení Hubbardton-forge 126703. Hubbardton Forge 126703 User Manual [en] Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Osvětlení Hubbardton-forge 126703