Hubbardton-forge 207697 Uživatelský manuál stáhnout pdf

HUBBARDTONFORGE.COM

-, -   

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

30321

Assembly & Installation Instructions

If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product.

We hope you enjoy your xture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this xture.

Please Note: This fixture is designed to be mounted on a

standard wall surface and may not be suitable for all ap-

plications. If installing in a non-wood frame application, we

recommend consulting a qualified builder or electrician.

Please Note: After installation, extra hardware and accessories may be

left due to kits being used on multiple products.

Component Parts

A Fixture Front

B Fixture Back

C Thumb Screws (2)

D Wall Mounting Bracket

E Anchors (4)

F #10 Screws (4)

G Electric Box Cover

H Cupped Washer

I Ground Screw

J Short #8 Black Screw

P Long #8 Black Screws (4)

To Mount Fixture to Wall (Figures 1 & 2)

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX

PRIOR TO INSTALLATION.

1. Carefully unpack the xture from the carton.

2. Fixture front (A) and back (B) are shipped installed. To

separate, remove thumb screws (C), and pull apart. Save

parts for later use. (Figure 1)

3. Remove short #8 black screw (J) from electric box cover (G)

and save for later use. Attach electric box cover (G) to wall

mounting bracket (D) using #8 black screw (J). With a

pencil, mark the location of all mounting holes in the wall

mount bracket (D) on the wall behind.

4. Drill 1/4" holes in the locations marked on the wall. For holes

using anchors, place the tapered end of the anchors (E)

into the holes and gently tap them ush to the wall using a

light weight hammer.

5. Thread the wires in the electrical box through the hole in the

wall mounting bracket (D) while moving the bracket into

position. Using the 1" #10 screws (F), screw the bracket

securely to the wall. Be careful not to over-tighten or

strip the anchors.

B308

Oceanus 3-Light Sconce 207697

Page 1 of 3

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND

PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with

applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.

(Figure 1)

(Continued)

1 2 3

Oceanus 3-Light Sconce 207697 1

Shrnutí obsahu

Strany 1 - Oceanus 3-Light Sconce 207697

Strany 2

If you need further assistance, or nd that you are missing any parts, please contact the dealer from which you purchased this product. We hope you en

Strany 3

Komentáře k této Příručce

Žádné komentáře

Hubbardton-forge 207697 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Osvětlení Hubbardton-forge 207697. Hubbardton Forge 207697 User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Osvětlení Hubbardton-forge 207697